Installation Guide

STEP 1: With Deck upside down, insert four Item A

screws through the four holes in the Deck. Turn Deck

back over and set on a level surface.

STEP 2: Align the Clamp Assembly

and secure to Deck using the four

screws and four Item B nuts. Do

not over tighten. Cut zip tie after

mounting.

Screws

Deck

Turn Over

ASSEMBLY

*You will need a #3 Phillips head screwdriver

and a 7/16” (11mm) socket or wrench.

Please Review and Verify Parts Included in Box:

HARDWARE KIT:

1. Clamp Assembly

2. Base

3. Knife Kit

4. Hardware Kit

Item A. (4) 1/4”-20 x 1-1/2” PH Phillips Screws

Item B. (4) 1/4”-20 Nuts

Item B

Item A

Quick Start Guide

for Magnum Shut-N-Cut #1901-26-01

PAGE 1
Quick Start Guide for Magnum Shut-N-Cut #1901-26-01 *You will need a #3 Phillips head screwdriver and a 7/16” (11mm) socket or wrench. Please Review and Verify Parts Included in Box: 1. Clamp Assembly 2. Base 3. Knife Kit 4. Hardware Kit Item B 1 2 Item A 3 HARDWARE KIT: 4 Item A. (4) 1/4”-20 x 1-1/2” PH Phillips Screws A. Item B. (4) 1/4”-20 Nuts B. ASSEMBLY STEP 1: With Deck upside down, insert four Item A screws through the four holes in the Deck.
PAGE 2
INSTRUCTIONS FOR USE 1 1 • Pull back on the red-capped Lock Lever to unlock the Clamp Arm. Pivot the Clamp Arm to the full‑open position. • Set insulation on the lower Clamp Bar so that the cutting slot is in-line with the desired cut. 2 Insert knife in slot • Close the Clamp Arm to compress the product, pressing down until the Lock Lever engages. 2 • Insert the EZ Insulation Knife (included) into the cutting slot on the Clamp Arm.