Instructions / Assembly

8
MAINTENANCE
CHANGING THE BLADE
WARNING
Blade is extremely sharp! Use hand protection when
removing, honing, or sharpening blade!
LUBRICATING
It is important to spray a fine layer of Slick Shot™ lubricant over the
power assembly at the points indicated (Shown Left) once every
month. Wipe down with WD40™ or a light machine oil to prevent
corrosion.
THE BLADE STOP
The blade stop may become worn. Remove anvil, turn blade stop
over for more use. Replacements can be purchased at your dealer.
(Page 3)
1. TURN SHEAR UPSIDE DOWN
Tip: put the shear on the edge of a sturdy table.
2. LOOSEN BLADE
Using a Phillips screwdriver, remove the Item D
screws.
3. REMOVE BLADE
Hold blade by each end and carefully lift out
of pocket.
4. INSTALL BLADE
Hold blade by each end and carefully place into the
blade pocket in the head, with the flat side of the
blade facing the table. Be sure that it is firmly seated
and the pocket is clear of debris.
5. TIGHTEN THE BLADE
Using a Phillips screwdriver, replace & tighten the
screws, starting with the center screw.
!
1
2
3
4 5
Hold by ends
Jack Screws