Use and Care Guide

DO NOT ALLOW HANDLE TO SLAM BACK
AFTER MAKING A CUT.
2
1
Your Magnum Shear™ is OPERATED MANUALLY.
The two-part handle is grasped by the operator and
pushed down to make a cut.
Unlock Safety Lock by pulling knob IN (see p. 4).
: Simply make your
first cut 1/8” to 1/4” (3 to 6 mm) longer than your mark,
then go back and make your second cut on your mark.
This is very useful to create a cleaner cut when a trim
molding or transition cannot be used to cover your cut end.
3
Insert material. It is recommended that you
until
the cut is complete.
ALWAYS KEEP HANDS AWAY FROM BLADE while
operating or carrying!
to cut.
Some effort may be required, depending on hardness
of material. ALWAYS KEEP HANDS AWAY FROM
BLADE while operating!
PUSH HANDLE DOWN
DOUBLE CUTTING
HONING
HOLD MATERIAL IN PLACE
MAINTAIN CONTROL OF HANDLE!
4
A burr may form on the flat side of the Blade within the first 30-100 cuts;
this is normal. Use the Hone Stone (included) to remove burr (see p. 7, #2).
Most materials (listed on p. 9) shear very well with just one cut. However, some brands of laminate flooring
and other products may require cutting twice to produce a better cut.
5
WARNING
It is advised that
protective gloves
and goggles are worn
when operating
the Magnum Shear
™
5
MAKING CUTS
USE EXTREME CAUTION! Blade is very sharp!