Use and Care Guide

C
B
A
narrow
M6 x 16 PHP Screw
wide
6
2
3
CUSTOM SETTINGS
has 2 edges: a 1/32” (0.75mm) narrow edge and a 3/16” (4.5mm)
wide edge. Either edge can be used according to the support needed to make a clean cut
(some soft-backed products require the wider anvil setting).
You may need to adjust the depth of the blade to cut all
the way through your product. You can do this by
Loosen the stop screw nut and turn stop screw until it is loose.
Release handle to open blade.
Push the handle down until the blade is resting on the “blade stop”
(see p. 8, #6).
Adjust the stop screw until it makes contact with the
power assembly. Tighten the stop screw nut.
the
anvil setting, remove the
M6 x 16 PHP Screws and flip
the anvil over.
THE ANVIL
SUPPORT
THICKNESS
BLADE DEPTH
TO CHANGE
ADJUSTING THE STOP SCREW:
M6 x 16 PHP Screw
Anvil Blade Stop
Blade Stop
Anvil
1
TO CUT APPROVED PRODUCTS
(see p. 9), loosen and
remove Phillips head screw on the “back stroke stop”;
turn the “back stroke stop” 180° and replace and
tighten Phillips head screw. For more convenience when
cutting thinner products, restore factory setting.
OVER 3/4” THICK
Stop Screw Nut
CAUTION: DO NOT OPERATE WITHOUT STOP SCREW IN PLACE - MAKE SURE IT IS SET CORRECTLY.
Factory Setting Set to cut over 3/4”
Handle
Stop Screw