Use and Care Guide

BLADE IS EXTREMELY SHARP!
USE HAND PROTECTION WHEN REMOVING,
HONING, OR SHARPENING BLADE!
8
Tip: Set the Magnum Shear™ on the edge of a sturdy bench or table
MAINTENANCE
5
It is important to spray a fine layer of light oil (10W
motor oil or WD-40®) over the Power Assembly at the
points indicated once every month to prevent surface corrosion.
The “blade stop” may eventually become worn. You can
remove the anvil and turn “blade stop” over for more use.
Replacements can be purchased from your dealer.
6
Anvil
Blade Stop
TURN THE MAGNUM SHEAR™ UPSIDE DOWN
WARNING!
CHANGING THE BLADE
PREVENTING CORROSION
THE “BLADE STOP”
C
LOOSEN THE BLADE:
Using a Phillips screwdriver,
remove the M6 X 16 PHP
screws.
TO REMOVE BLADE:
hold blade by each end
and carefully lift out of
blade pocket.
TO INSTALL BLADE:
Hold blade by each end and
carefully place into the
blade pocket in the power
assembly, with the
flat side
of the blade facing the table
.
Be sure that it is firmly
seated and that the pocket
is clear of debris.
TIGHTEN THE
BLADE: Using a
Phillips screwdriver,
replace & tighten
the M6 x 16 PHP
screws,
starting
with the
center
screw.
A-B
D
B
A
4
Flat Side toward table
Beveled Side out
C
E
!
!