Use and Care Manual

Item F
Tools needed: #2 & #3 Phillips head screwdrivers.
IMPORTANT! Start all screws BY HAND when assembling your shear. This will help avoid cross-threading.
1. ATTACH R AILS
2. ATTACH TAIL
Quick Start Guide
for Magnum Shear Models #909, #913, #920, #926
3. ATTACH TABLE
A. Attach front of table to base, using Item D screws.
Tighten with #3 Phillips.
B. Attach back of table to tail using Item E screws.
Tighten with #2 Phillips.
4. AT TACH HAN D LE
5. ATTACH FENCE
Insert fence into one of the six hole sets on the table:
there are two 90º and four 45º locations. The fence is
friction fit (requires effort to insert or remove).
5
Item E
(1) Power Assembly
(1) Handle Assembly
(1) Fence
(1) Table
The Hardware Kit is used in multiple models. Your Shear may not use all of the items listed.
(1) Tail
(2) Rails
(1) Hone Stone
(1) Hardware Kit
In the Box: In the Hardware Kit:
2
1
4
Tail
Power Assembly
Item D
3B
3A
Attach rails to Power Assembly base using
Item A screws, fitted with Item B star washers.
Attach tail to rails using Item C screws.
Make sure holes in tail are facing up.
ASSEMBLING YOUR SHEAR
Remove handle bolt Item F
from handle, and install in
camshaft. Insert handle into
camshaft. Note: Backstroke
Stop must be on top! Tighten
with 10mm hex wrench
Item G.
Do NOT remove plastic
tie and orange tag until
handle is bolted in place
Item A. (4) 8mm x 60mm PH Phillips Machine Screws
Item B. (4) M8 Star Washers
Item C. (4) 8mm x 25mm PH Phillips Machine Screws
Item D. (6) 6mm x 16mm PH PHillips Machine Screws
Item E. (5) #10 x 1 PH Phillips Self Tapping Screws
Item F. (1) M16 x 50 BHCS (Pre-Installed in Cam)
Item G. (1) 10mm Hex Wrench
HANDLE UNDER
EXTREME PRESSURE
DO NOT ALLOW TO
SLAM BACK!