Manual

Forproductsthickerthan1”,

Lowerbladeto1/2

ofproductthickness.

1” OR LESS

OVER 1”

1” OR LESS

OVER 1”

Forproducts1”orthinner,

Lowerbladeto1/4”

belowtablesurface.

opeRation/USe:

1) RemoveBladeCover(notshown)

2) SetCutWidth:

Loosenhorizontaladjustmentknob

Movebladecarriagetodesiredposition

Tightenhorizontaladjustmentknob

Centersupportblockunderblade

3) SetCutDepth

Loosenheightadjustmentknob

Tightenheightadjustmentknob

4) Setsheetoffoamontabletopandlightlypressagainstleftfence.

 Pushintobladewithsteadyrmpressure

 Astheproductmovesbeyondthetable,haveyourhelperpulllightly

to ensure a smooth cut.

 Tonishthecut,pushwithapieceofsacricialmaterialor

apushstickforthelast6”toavoidinjury.

MaintenanCe:

1) SeveralcomponentsoftheMagnumRigidFoamCuttershouldbe

 lubricatedregularlywithSlickShot™,Grease,orSprayOil,asshown.

2) TosharpenBlade:

 • WEARKEVLARORCUTRESISTANTLEATHERGLOVES.

 • Liftbladeto1”abovethetable.

 • InsertFurii™diamondsharpenerunderblade.

 • Rotateblade3timeswhileapplyingpressurewithsharpener.

3) ToReplaceBlade:

 • WEARKEVLARORCUTRESISTANTLEATHERGLOVES

 • Removeaxleboltwitha

  3/16”allen(Hex-Key)wrench

and a 7/16” wrench

 • RemoveBlade

 • ReassemblewithNewBlade

Lube