User Manual

INSTRUCTIONS FOR USE

Insert knife

in slot

Clamp Pressure Adjustment

1) Remove the wingnuts.

2) Move the spring-rest pins to the desired setting.

For very low pressure, remove the pins completely.

3) Replace the wingnuts.

STEP 1: With Deck upside down, insert four Item A

screws through the four holes in the Deck. Turn Deck

back over and set on a level surface.

STEP 2: Align the Clamp Assembly

and secure to Deck using the four

screws and four Item B nuts. Do

not over tighten. Cut zip tie after

mounting.

Screws

Deck

Turn Over

ASSEMBLY

SET UP

WELCOME! YOUR MAGNUM SHUTNCUT COMES READY TO ASSEMBLE.

*You will need a #3 Phillips head screwdriver

and a 7/16” (11mm) socket or wrench.

Please Review and Verify Parts Included in Box:

HARDWARE KIT:

1. Clamp Assembly

2. Base

3. Knife Kit

4. Hardware Kit

Item A. (4) 1/4”-20 x 1-1/2” PH Phillips Screws

Item B. (4) 1/4”-20 Nuts

• Pull back on the red-capped Lock Lever to unlock the Clamp

Arm. Pivot the Clamp Arm to the full-open position.

• Set insulation on the lower Clamp Bar so that the cutting slot

is in-line with the desired cut.

• Close the Clamp Arm to compress the product, pressing

down until the Lock Lever engages.

• Insert the EZ Insulation Knife (included) into the cutting

slot on the Clamp Arm.

• Cut through the insulation product with a sawing motion,

drawing the blade toward you.

wingnut

Item B

Item A

wingnut