ASSEMBLY & OPERATING INSTRUCTIONS MODEL #98307 MODEL #98308 BULLET SINGLE SIDEBURNER STAINLESS STEEL, L.P. (PROPANE) BULLET SINGLE SIDEBURNER STAINLESS STEEL, N.G.
TABLE OF CONTENTS PAGE # SAFETY INSTRUCTIONS……………………...…………………………………………………….………………………..………………………...2 THE LOCATION FOR YOUR SINGLE SIDEBURNER..................……..…….….……………………….....……….…………………........2 CHECKING FOR GAS LEAKS………………………………………………………………………………………...…..……………………..2 NATURAL GAS SAFETY…………………………………….……………………….……..………………….……………….…..…….……...3 PROPANE GAS SAFETY…………………………………………………………………………………………………….….………………..4 INSTALLATION INSTRUCTIONS…………………………………………………………………………………………..………………….…….....
SAFETY INSTRUCTIONS READ CAREFULLY BEFORE ASSEMBLY AND OPERATION OF YOUR SINGLE SIDEBURNER This single sideburner must be installed in accordance with local codes or, if in an area without local codes, with the latest edition of the National Fuel Gas Code ANSI Z223.1. In Canada, installation must conform to the standard CAN/ CGA 1-b149.1 and/or .2 (Installation Code for Gas Burning Appliances and Equipment) and any local codes.
SAFETY INSTRUCTIONS (CONT.) NATURAL GAS SAFETY Your natural gas single sideburner is designed to operate on natural gas ONLY, at a pressure of 4” water column (W.C.) regulated at the natural gas regulator and natural gas orifice located inside the ventri tube. Check with your gas utility for local gas pressure and with your local municipality for building code requirements.
SAFETY INSTRUCTIONS (CONT.) PROPANE GAS SAFETY Your propane single sideburner is designed to operate on propane gas ONLY, at a pressure of 11” water column (W.C.) when equipped with a propane regulator on the supply line regulated at the residential meter and a propane orifice located inside the ventri tube.
INSTALLATION INSTRUCTIONS READ CAREFULLY BEFORE ASSEMBLY AND OPERATION OF YOUR SINGLE SIDEBURNER Your single sideburner comes to you fully assembled. We strongly recommend professional installation and hookup of the single sideburner. These instructions will provide you with the measurements necessary for you or your builder to construct a masonry structure to house your outdoor single sideburner. NOTE TO INSTALLER: Leave these instructions with the consumer for future reference.
INSTALLATION INSTRUCTIONS (CONT.) OUTDOOR NATURAL GAS SINGLE SIDEBURNER INSTALLATION SPECIFICATIONS NOTE: - Vents must be provided for combustion air and ventilation on both sides of built-in cabinet. - When choosing a location for your single sideburner keep in mind that it should never be located under any overhead combustible construction. - The sides and back of the single sideburner should not be any closer than 21 inches to combustible construction.
INSTALLATION INSTRUCTIONS (CONT.) OUTDOOR PROPANE GAS SINGLE SIDEBURNER INSTALLATION SPECIFICATIONS NOTE: - Vents must be provided for combustion air and ventilation on both sides of built-in cabinet. - When choosing a location for your single sideburner keep in mind that it should never be located under any overhead combustible construction. - The sides and back of the single sideburner should not be any closer than 21 inches to combustible construction.
INSPECTING I CLEANING BURNER AND GAS VALVE By following these cleaning procedures on a timely basis, your single sideburner will be kept clean and working properly with minimum effort. CAUTION – Always turn off the gas supply prior to clearing your single sideburner. BURNER CLEANING 1. Remove the cooking grate. 2. Remove the outer brass ring and inspect all ports. If there is a clogged port, bend a stiff wire into a small hook and run the hook through the port several times. 3.
INSPECTING / CLEANING BURNER AND GAS VALVE (CONT.) CAUTION – Always turn off the gas supply prior to clearing your single sideburner. IGNITER CHECK With the control knob set to “OFF”, check the igniter for presence of spark at burner. Push control knob in fully and turn slowly about a 1/4 turn to the left (counter-clockwise) until a click is heard; the trigger hitting the strike block should produce a blue spark at the igniter tip. Return control knob to “OFF”.
LIGHTING & OPERATING INSTRUCTIONS CAUTION: TO ENSURE YOUR SAFETY, DO NOT OPERATE SINGLE SIDEBURNER UNTIL YOU FULLY READ AND UNDERSTAND THE INSTRUCTIONS. LIGHTING PROCEDURES Lighting Burner: 1. Become familiar with the safety guidelines at the front of the manual. DO NOT SMOKE WHILE LIGHTING SINGLE SIDEBURNER OR CHECKING GAS SUPPLY CONNECTIONS! 2. If your single sideburner fuel source is a LP gas cylinder, check to see that cylinder is filled. 3.
CLEANING & MAINTENANCE CAUTION: ALWAYS ALLOW THE SINGLE SIDEBURNER TO COOL COMPLETELY BEFORE CLEANING. CLEANING THE COOKING GRATE After cooking, turn control knob to “OFF” and let single sideburner cool before attempting to clean your cooking grate. Before first use and periodically it is suggested that you wash the cooking grate in a mild soap and warm water solution. You can use a washcloth or a vegetable brush to clean your cooking grate.
TROUBLESHOOTING IF SINGLE SIDEBURNER FAILS TO OPERATE PROPERLY 1. Turn off gas at source, turn control knob to “OFF”, and wait five minutes before trying again. 2. Check gas supply/connections. 3. Repeat lighting procedure. If single sideburner still fails to operate properly, TURN “OFF” GAS AT SOURCE, TURN CONTROL KNOB TO “OFF”, wait for sideburner to cool, and check the following: a. Misalignment of burner tube over ventri tube CORRECTION: Reposition burner tube to properly seat inside ventri tube. b.
PARTS LIST MODEL #98307 MODEL #98308 BULLET SINGLE SIDEBURNER STAINLESS STEEL, L.P. (PROPANE) BULLET SINGLE SIDEBURNER STAINLESS STEEL, N.G.
EXPLODED ILLUSTRATION 14
LIMITED WARRANTY Bull Outdoor Products, Inc. warrants to the original purchaser at the original site of delivery with proof of purchase of each Outdoor Gas Sideburner that when subject to normal residential use, it is free from defects in workmanship and materials for the periods specified below. This warranty excludes sideburners used in rental or commercial applications.