Use and Care Manual

ManualsBrandsBullet ManualsOutdoor CookingStainless Steel Liquid Propane Single Side Burner

LIGHTING & OPERATING INSTRUCTIONS

CAUTION: TO ENSURE YOUR SAFETY, DO NOT OPERATE SINGLE SIDEBURNER UNTIL YOU FULLY READ AND UNDERSTAND THE

INSTRUCTIONS.

LIGHTING PROCEDURES

Lighting Burner:

1. Become familiar with the safety guidelines at the front of the manual. DO NOT SMOKE WHILE LIGHTING SINGLE SIDEBURNER OR

CHECKING GAS SUPPLY CONNECTIONS!

2. If your single sideburner fuel source is a LP gas cylinder, check to see that cylinder is filled.

3. Check that the valve orifice is properly seated inside the ventri tube.

4. Make sure all gas connections are securely tightened. TEST FOR LEAKS WITH A SOAP SOLUTION, NEVER WITH A FLAME. (Gas Leak

Check instructions are on page 2).

5. Always open lid before lighting.

6. Set control knob to “OFF” and open gas supply, LP cylinder or natural gas valve.

7. To ignite the burner: Push in control knob completely and rotate slowly (3 to 4 seconds) about 1/4 turn to the left (counter clockwise) until a click

is heard. The 3 to 4 second duration should provide enough gas to light the burner. If the burner does not light, immediately return the control knob

to ‘OFF’, wait several minutes for the gas to disperse, and repeat the process.

8. Adjust control knob to desired cooking temperature.

NOTE: If igniter fails to produce a spark at the electrode tip, burner can be manually lit with a fireplace-type match.

NOTE: To light the single sideburner with a fireplace-type match, follow steps 1 through 6 above. Remove cooking grate and insert lighted

fireplace-type match or long-necked butane lighter placing flame near to burner ports. Press in control knob and rotate left to “HIGH” setting to

release gas. Burner should light immediately. Replace cooking grate and adjust burner to desired cooking temperature.

OPERATING PROCEDURE

Burn-off: Before cooking on your single sideburner for the first time, burn the sideburner to get rid of any odors or foreign matter by igniting the

burner and operating at “HIGH” setting for about five minutes. You may then either set the control to “OFF” or cook on your single sideburner

immediately by turning the control knob to a lower setting.

CAUTION: DO NOT LEAVE SINGLE SIDEBURNER UNATTENDED WHILE IN USE.