Owner`s manual

Page 12 Bullfrog Spas Owner’s Manual
INITIAL START-UP
Important: Bullfrog Spas come with either an Standard,
Deluxe, or Limited Control System. Refer only to the
Control System that applies to your spa.
STANDARD CONTROL SYSTEM:
When your spa is first activated, it will go into Priming
mode, indicated by “Pr” on the display. The Priming
mode will last for less than 5 minutes and then the spa
will begin normal operation in Standard Mode. By
default, the spa will begin to heat until it reaches the
start-up temperature of 100°F.
DELUXE CONTROL SYSTEM:
When your spa is first activated, it will go into Priming
mode, indicated by “Pr” on the display. The Priming
mode will last for less than 5 minutes and then the spa
will begin normal operation in Standard Mode. For the
first one minute, “—F” will appear on the display while
the system is sensing the water temperature. By default,
the spa will begin to heat until it reaches the start-up
temperature of 100°F.
Note: The Priming Mode can be accelerated by pressing
the “Jets 1” button and then the “Warm or Cool” button.
LIMITED CONTROL SYSTEM:
When your spa is first actuated, it will go into Priming
mode. Please see the M-7 Installation Instruction Manual
for complete instructions on Power-up and Pump
Priming. The Priming mode will last for less than 5
minutes and then the spa will begin to heat the spa and
maintain the water temperature in the Standard mode