Owner`s manual

Page 22 Bullfrog Spas Owner’s Manual
Action Required: No action required. Freeze protection
has initiated as described above. (This message will
appear for up to two minutes right after very cold water
is sensed, if pump 1 was only turned on due to this
reason.)
“PRIMING MODE TAKES 4 MIN” on Display:
When your spa is first actuated, it will go into Priming
mode.
Action Required: See the M-7 Installation Instruction
Manual for complete instructions on Power-up and
Pump Priming. The Priming mode will last for less than
5 minutes and then the spa will begin to heat the spa
and maintain the water temperature in the Standard
mode.
“BACKUP FAIL” on Display: Internal problem
detected.
Action Required: Repair required. Contact you author-
ized Bullfrog Portable Spa Dealer for service.
“STANDBY MODE” on Display: Standby Mode
has been activated by pressing a button combination on
user panel.
Action Required: Press any button to leave Standby
Mode and return operation.
“PH LOW RAISE PH” on Display: pH is low.
Action Required: Add pH increaser according to
manufacturer’s instructions.
“PH HIGH RAISE PH” on Display: pH is high.
Action Required: Add pH decreaser according to
manufacturer’s instructions.
“SANITIZER LOW” on Display: Sanitizer is low.
Action Required: Add sanitizer according to
manufacturer’s instructions.
“SANITIZER HIGH” on Display: Sanitizer is high.
Action Required: Remove spa cover and allow sanitizer
to dissipate.
Warning! Shock Hazard! No User Serviceable Parts.
Do not attempt service of this control system. Contact
your authorized Bullfrog Portable Spa Dealer for assis-
tance. Follow all owner’s manual power connection in-
structions. Installation must be performed by a licensed
electrician and all grounding connections must be
properly installed.