Installation manual

ST2 OPERATION
SRC2 REMOTE CONTROL WITH RNET CONTROLLER
SRC2 Remote Control Operation
Turning the unit on
The tuner is power managed by the RNET-enabled
controller. If the tuner is in standby mode, any button
press of the SRC2 will bring the tuner out of standby
mode when used with the UNO keypad.
Selecting the tuner
To select a tuner, push until the desired tuner
is selected, or use the numeric source inputs at the
bottom of the SRC2.
Selecting the desired band
Push to toggle between AM/FM reception.
Selecting the desired frequency
Use the Channel and or and
for manual tuning. To move quickly through the sta-
tions, press and hold the button for more than 1.5
seconds. To directly select a station, enter the three-
or four-digit channel or frequency (1071 for 107.1,
etc.). European regions use five-digit station frequen-
cies.
Frequency Seek
The SEEK function is performed by pressing and
releasing the Select or or . To seek
higher frequency station press . Press for
lower frequencies. Tuning begins at the current fre-
quency, seeks upward (or downward) and stops at the
next tuned station. Pushing or again con-
tinues the SEEK function. Once the highest frequency
is reached, the tuner continues SEEK mode at the
lowest frequency.
Frequency Scan
To scan, press and hold then release . The
tuner scans through tuned stations with a 5-second
preview before moving to the next station. To end
scanning, press again.
Bank/Memory Presets
The AM/FM tuner has six banks of preset memory
settings, and each bank holds six presets for a total
of 36 possible presets.
Selecting a Bank
To select a bank, press and hold for bank up
or for bank down.
Saving a Memory Preset
Press and hold numeric buttons (1-6) for saving mem-
ory presets.
Recalling a Memory Preset
Press and to scroll through a loop dis-
play of all the configured memory presets for the cur-
rently selected bank. Only configured presets will be
displayed.
Mute
Press the button to mute/unmute the tuner
audio output.
19