Owner`s manual

Installation and Setup

Step 4: Fill the Spa: Fill the spa to the water level indication

mark on the faceplate of the lter assembly by placing

the hose into the lter compartment through the Weir

door. NOTE: The higher the water level in the spa, the

fewer spa users the spa will accommodate before

overowing. NOTE: For complete instructions on lling the

spa, refer to Changing Spa Water.

IMPORTANT: Never ll the spa with soft water unless an

appropriate mineral supplement is immediately added

(see your authorized Bullfrog Spa dealer). If your water is

extremely hard, it is preferable to either dilute the water’s

hardness by blending the water with water from a water

softener, or by the addition of a special water softening

chemical (see your authorized Bullfrog Spa dealer).

IMPORTANT: Air pockets can result inside the pumps and in

the main plumbing intake if the spa is not lled through

the lter compartment.

Step 5: Check for Leaks: After the spa is lled, check

all ttings and equipment for signs of leakage before

turning on the spa. Turn on pump(s), once again, check

for leakage. If a leak is detected, tighten the tting by

hand. If the leak persists contact your authorized Bullfrog

Spa dealer.

Step 6: Install Cover: The spa cover comes with tie-down

straps and locking hardware that attaches the cover to

the spa or decking. If your dealer did not install the cover,

refer to the Cover Installation Instructions included with

the cover.