Owner`s manual

Preset Filter Cycles
The pump and ozone generator* will run during filtration. At the start of each cycle, the blower will run on
highest speed for 30 seconds to clean out the air channels. The lowest speed of pump 2 will run for 5
minutes.
There are two filter cycles per day. The first filter cycle will automatically activate at 8:00 a.m. and will
operate for 2 hours. The second filter cycle will automatically activate at 8:00 p.m. and will operate for 2
hours.
Freeze Protection
If the temperature sensor detects a drop to 44°F (6.7°C) within the heater, the pump automatically
activates to provide freeze protection. The pumps will turn off once the sensor have detected a
temperature of 44°F (7.2°C) or higher.
Clean-Up Cycle (optional)
A clean-up cycle begins 30 minutes after the pump is turned off or times out. The pump and ozone
generator* will run for one hour.
*Ozone Generator (optional)
The ozone generator runs during filter cycles (except when pump 1 is operating on high speed) and
during clean-up cycles.
Bullfrog Spas Owner’s Manual
17