Owner`s manual

JetPaks™
To identify the type of JetPak™, locate the identification number found
on the backside of the JetPak (e.g. J03-63-12).
This number provides the following information:
 Style of JetPak (J03 = style number 03)
 Water Flow Rate of JetPak (63 = 63 gallons per minute)
 Number of Jets (12 = 12 jets)
INTERCHANGING JetPaks™
1. Put the spa in Standby mode, this will prevent the pump(s) from
activating (see the Operation section).
2. Remove the headrest pillow.
3. Carefully, remove the SnapCap™ (top mounting plate) by lifting
upwards with your hands.
4. Push the JetPak™ forward until you have enough room to reach
the two PVC water unions and air line union.
5. Disconnect the air line union.
6. Loosen the two PVC unions, pull the manifold out from in between
the two water unions and remove the JetPak™ from the JetPod.
7. Exchange the JetPak™ with another JetPak™.
8. Reattach the JetPaks™ by reverse the above procedure.
Important: Spa models with two pumps have two different JetZones.
These JetZones are divided by a JetZone divider. Never operate the
spa without the JetZone divider in place. Doing so will cause serious
damage to the pumps. In addition, interchanging JetPaks™ from one
JetZone to another may result in improper water flow to one or more
JetPaks™. If you have questions or problems, please contact your
authorized Bullfrog Portable Spa dealer.
Bullfrog Spas Owner’s Manual
20