Owner`s manual

JETZONES
Bullfrog Portable Spas powered by two pumps provide a
unique feature called JetZones. A JetZone is a region of
jets that are all powered by the same pump. With
JetZones, you decide which JetPaks are powered by each
pump. Two-pump spa, have two JetZones.
By simply moving the JetZone divider, you can either
increase or decrease the number of JetPaks that are
powered by a particular pump, thus creating a new
JetZone. By adding JetPaks to a particular JetZone, you
will decrease the power to that zone. By removing
JetPaks from a particular zone, you will increase the p
to that zone.
ower
TO CREATE A NEW JETZONE
1. Put the spa in Standby mode, this will prevent the
pump) from activating (see the Operation section).
2. Remove the headrest pillow.
3. Carefully, remove the SnapCap™ (top mounting plate)
by lifting upwards with your hands.
4. Push the JetPak™ forward until you have enough
room to reach the two PVC water unions and air line
union.
5. Disconnect the air line union.
6. Loosen the two PVC unions, pull the manifold out from
in between the two water unions and remove the JetPak™ from the JetPod.
7. Remove the JetZone divider and reattach the JetPaks™ by reverse the above procedure.
8. Install the JetZone divider in a location of your choice.
Important: Never operate the spa without the JetZone divider in place. Doing so will cause serious
damage to the pumps.
Bullfrog Spas Owner’s Manual
22