Owner`s manual

LIGHT BULB REPLACEMENT

To replace a burned out or defective light bulb,

complete the following:

1. Disconnect electrical power supply.

2. Remove equipment compartment door.

3. Locate the back of the light fixture.

4. Grasp the light bulb holder (located on the back of

the light fixture).

5. Twist counter-clockwise to release light from

fixture.

6. Pull light bulb holder out of the fixture.

7. Replace light bulb and reinstall light fixture.

8. Replace equipment compartment door.

9. Restore electrical power supply.

Note: For alternate lighting systems, contact your authorized Bullfrog Portable Spa dealer.

OZONE STERILIZER REPLACEMENT

On front of the Ozone Sterilizer (optional) is the indicator light. To verify that the Ozone Sterilizer is

working properly, check the indicator light while the filter pump is running. The Ozone Sterilizer will shut

down for 30 minutes after the JETS button has been pressed.

If the indicator light does not glow while the filter pump is

running, follow these steps:

1. Disconnect electrical power supply.

2. Locate and unplug the Ozone Sterilizer from the

control center.

3. Disconnect the output tubing from the Ozone S

Remove th

terilizer.

4. e mounting screws that hold the Ozone

5. ne Sterilizer to your authorized

6. Ozone Sterilizer by reverse the above

Sterilizer in place.

Take the entire Ozo

Bullfrog Portable Spa dealer. The unit will be check

to verify that it is defective. If not, request a service

call.

Reinstall the

procedure.

Bullfrog Spas Owner’s Manual