Owner`s manual

Spa light does not work:
Cause #1: Light bulb has burned out.
Solution: Replace light bulb.
Cause #2: Lighting system is defective.
Solution: Contact your authorized Bullfrog Portable Spa dealer.
Spa pump will not turn on, creates a burning smell while running, or makes excessive noise while
running:
Cause: Pump motor is defective.
Solution: Contact your authorized Bullfrog Portable Spa dealer.
Jets surge on and off:
Cause: Water level is too low.
Solution: Adjust water to the water level indication on the faceplate of the filter assembly.
Jets are weaker than normal or do not work at all, but the pump is running:
Cause #1: Jet handle(s) are partially or fully closed.
Solution: Open jet handle(s).
Cause #2: Filter cartridge is dirty.
Solution: See “Cleaning the Filter”.
Cause #3: There is air trapped in the spa equipment or its face piping.
Solution: Open the air bleed valve on each pumps housing and allow air to bleed out of the system.
Be sure to tighten each air bleed valve as soon as water starts to flow.
Cause #4: The suction fitting(s) are blocked.
Solution: Remove any debris that may be blocking the suction fitting(s).
Cause #5: The JetZone divider is not installed (if applicable).
Solution: Re-install in the appropriate JetPak.
Note: Running the spa without a JetZone, divider can cause serious damage to the pumps.
Cause #6: Slice valve is closed.
Solution: Open valve and secure with valve keeper.
Bullfrog Spas Owner’s Manual
33