Troubleshooting guide

WARNING: An empty spa (spa without water in it) must not be left exposed

to sunlight as shell damage may occur. Once the spa is unwrapped, ll spa

with water immediately or shade the spa with cover or wrapping to prevent

direct exposure to sunlight.

IMPORTANT: Do not turn power on to the spa without water in the spa.

Serious damage to the pump and heater may occur.

Step 1: Fill the Spa: Use a garden hose to ll the spa to the water level indica-

tion mark on the faceplate of the lter weir assembly.

NOTE: For complete lling instructions, refer to Changing Spa Water (page

55).

IMPORTANT: Never ll the spa with soft water unless an appropriate

mineral supplement is immediately added (see your authorized Bullfrog Spas

Dealer). If your water is extremely hard, it is preferable to either dilute the

water’s hardness by blending the water with water from a water softener, or

by the addition of a special water softening chemical (see your authorized

Bullfrog Spas Dealer).

Step 2: Check for Leaks: After the spa is lled, check all ttings and equip-

ment in equipment compartment for signs of leakage before turning on the

spa. Turn on pump(s), once again, check for leakage. If a leak is detected,

tighten the tting by hand. If the leak persists contact your authorized Bull-

frog Spas Dealer.

Filling Your Spa

Step 3: Install Cover: e spa cover comes with tie -down straps and locking

hardware that attaches the cover to the spa or decking. If your dealer did not

install the cover, refer to the Cover Installation Instructions included with the

cover.

Cover locks are an essential component for compliance with the ASTM

F1346-91 safety standard for spa covers.