Troubleshooting guide

30
Utilities
Start display of string. There is a 2 second delay on each number.
Start display of string. There is a 2 second delay on each number.
Start display of string. There is a slight delay on each number.
These strings will display once
and return to the beginning.
Press Temperature again to
display the string again.
Waiting 10 seconds will allow
the screen to return to
normal operation.
Only if GFCI
is enabled
To FIRST item in
Main Menu
(TEMP Range)
While the Temperature is
menu
repeatedly until UTIL (Utilities)
appears in the LCD.
SET
RANGE
Main Screen
READY
RANGE
FLTR1
SET SET
When set to ON, Panel will display
alternate readings from
Senor A and Sensor B
on Main Screen
DIP Switch 1 – Test Mod
N/A or Special Amperage Rule 1 or 2
120 or 240 VAC input power
sensed by a
UL system at startup.
Heater Type
Displays Fault Log
Displays GFCI Test Menu
DIP Switch 2+3+4 = the number of HS pumps with heat
Store Settings (0) or Memory Reset (1)
DIP Switch
Settings
Waiting
Several Seconds
Reverts to Original Setting
To Set
*****
Indicates Flashing or Changing Segment
Key
A temperature button, used for “Action”
menu or dedicated “Choose” button, depending on control panel
Indicates Alternating or Progressive Message - every 1/2 second
Waiting time that keeps the last change to a menu item.
Waiting time (depends on menu item) that reverts to original setting and
ignores any change to that menu item.
*****
Indicates a Menu Item that
Depends on a Manufacturer
Con
guration and
may or may not appear.
Utilities
Main Menus
Main Screen
Menu Button
P
SET
RANGE
SET
While the Temperature is
still ashing, press Menu.
SET
RANGE
READY
RANGE
FLTR1
Main Screen
READY
RANGE
FLTR1
READYSET
1
2
Power-up Screens
Each time the System powers up, a series of numbers is displayed.
After the startup sequence of numbers, the system will enter Priming Mode (See Page 3).
Waiting 30 Seconds in the Main Menu
will allow the display to revert to the Main Screen.
Most changes are not saved unless Menu is pressed.
Refer to Key above.
If Time of Day is not set
“SET TIME” will
appear in this menu.
SET
Indicates Flashing or Changing Segment
Key
A temperature button, used for “Action”
Menu or dedicated “Choose” button, depending on control panel conguration
Indicates Alternating or Progressive Message - every 1/2 second
Waiting time that keeps the last change to a menu item.
Waiting time (depends on menu item) that reverts to original setting and
ignores any change to that menu item.
*****
Navigation
Navigating the entire menu structure is done with 3 buttons on the control panel.
Temperature buttons are indicated by a single button icon.
Warm and Cool can both be uesd to simplify navigation and
programming where a single Temperature icon is shown.
The MENU Button is also used to
choose the various menus and navigate each section. Pressing
the MENU button from the main screen (normal operation) will
enter the menus.
Typical use of the Temperature button(s) allows changing the Set
Temperature while the numbers are fl ashing in the LCD.
Pressing the MENU button while the numbers are fl ashing will also
enter the menus.
The menus can be exited with certain button
presses. Simply waiting for several seconds will also
return the panel to normal operation.
KEY