Troubleshooting guide
35
Water Features
Waterfall features may be equipped with an in-line lter screen that lters
debris out of the water that would otherwise aect the performance of the
water feature. e in-line lter should be cleaned anytime the water feature
seems to have reduced ow and/ or the water feature seems disrupted.
A & R Series Spas
NOTE: Always makes sure the water feature is in the OFF position when
the spa cover is in place! e water feature is turned on or o by adjusting the
Water Feature Control Valve located next to the water feature.
e water feature lter is located in the spa equipment area directly above
the Control Center in A7, A7L, A6L, A5, R7, R7L, R6, and R5 models. (See
diagram page 8).
e water feature lter is located on the backside of the Cascadia™ (216)
JetPak directly below the main manifold in A8, A8D, and A8L models.
NOTE: To remove the screen for cleaning the spa must be drained or the ¾”
line must be clamped o as this has been installed below water level. Follow
steps 2 through 4 as described on the this page.
SportX Series Spas
e water feature lter is located on the backside of the Cascadia™ ( J16)
JetPak directly below the main manifold. is only applies to the SportX
series spas equiped with the Cascadia ( J16) JetPak.
Step 1: Remove the JetPak and locate the in-line debris lter screen on the
back of the JetPak.
Step 2: Unscrew the tting to expose the strainer.
Step 3: Manually remove any visible particles and debris. Rinse to remove
smaller particles.
Step 4: Replace lter screen and re-tighten tting.