Troubleshooting guide
41
SPA MAINTENANCE
WARNING: An empty spa (spa without water in it) must not be left
exposed to sunlight as shell damage may occur. Once the spa is unwrapped, ll
spa with water immediately or shade the spa with cover or wrapping to
prevent direct exposure to sunlight.
Changing Spa Water
As you use your spa, soap and detergent residues from your skin and bathing
suits, along with other substances from maintaining the spa’s water chemistry
will accumulate in the spa water and make maintaining the water more dif-
cult. Rinsing your bathing suits and showering without soap prior to entering
your spa will increase the life of your spa water. Depending upon usage, the
spa water will need to be changed every 1-4 months or when the water chemi-
cal levels become dicult to manage. When changing spa water, remove all
JetPaks®. Clean the shell and JetPod™ areas with a spa surface cleaner. See
Spa Shell Care. Clean the other areas of the spa, including JetPaks, with a spa
surface cleaner as necessary.
IMPORTANT: Drain your spa to an area that can handle a large quantity
of water. If draining water onto vegetation, make sure that the sanitizer level
(Chlorine or Bromine) of the water is less than 0.5 PPM.
WARNING: Avoid drainage that can lead into basement window wells or
any other area where damage could occur.
To Drain Your Spa :
Step 1: Turn-o main electrical breaker to spa.
Step 2: Locate drain below equipment compartment door.
Step 3: Pull the drain out with a slight clockwise turn. Use pliers if needed.
NOTE: Drain is fully extended at approximately 2 inches (5 centimeters).
Step 4: Remove drain cap.
NOTE: e drain spout will not drain when fully extended.