Troubleshooting guide

Step 5: Attach a standard garden hose. Push the drain spout in halfway to

actuate the drain.

NOTE: e Spa will drain about 5 gallons (20 liters) per minute. Ensure that

the drainage is in an area safely away from window wells or basement entries.

Step 6: Once the spa is fully drained, pull the drain spout out all the way,

remove hose, replace the drain cap and push drain in all the way.

To Rell Your Spa:

WARNING: When relling the spa, always Super Sanitize the new water

by adhering to the instructions in the Water Chemistry section.

Step 1: To avoid air pockets in the pump(s), rell the spa with water by plac-

ing the hose into the lter compartment through the Weir door. Fill to the

water level indication on the faceplate of the lter assembly.

Step 2: Restore electrical power supply.

Step 3: Press any button to reset the control system.

Step 4: Following instructions in Starting the Spa with New Water (page 16).

Filter Maintenance

It is recommended that pleated lter cartridge(s) be cleaned every 3-6 weeks or

as needed. Spas equipped with the optional circulation pump system may require

increased cleaning intervals based on use and local water conditions. Replace the

lter cartridge(s) To maintain warranty protection, use only genuine Bullfrog

Spas Filter Cartridge replacements. To clean or replace your lter cartridge(s),

complete the following:

CAUTION: Never operate spa with the lter(s) removed.