Troubleshooting guide
44
Light Bulb Replacement
Standard Replacement- SportX Series Only
To replace a burned out or defective standard light bulb, complete the following:
Step 1: Turn o the electrical power at the breaker box.
Step 2: Remove the equipment compartment door.
Step 3: Locate the back of the light xture.
Step 4: Grasp the light bulb holder (located on the back of the light xture)
and twist counter-clockwise to release the light from the xture.
Step 5: Remove the light bulb by pulling it straight out of the light bulb holder.
Step 6: Replace the light bulb and reinstall the light bulb holder.
Step 7: Replace the equipment compartment door.
Step 8: Restore the electrical power supply.
NOTE: For alternate lighting systems, contact your authorized Bullfrog Spas
Dealer.
LED Replacement- A&R Series Only
Contact your authorized Bullfrog Spas Dealer for repair.
Spa Shell Care
General Cleaning
For normal cleaning, use a mild dishwashing soap, window cleaner, or other
products recommended by your local authorized Bullfrog Spas Dealer. For
stubborn stains, use a mild acrylic cleaner or a mild detergent. To apply these
cleaners, use a soft, damp cloth or sponge. Rinse well and dry with a clean
cloth. To clean hard water stains, remove light scratches and protect your spa
shell, contact your authorized Bullfrog Spas Dealer.
Cleaning the Scum Line
With normal use of the spa, oils, lotions, and hair products will build up on
the surface of the water. is will leave a scum line around the perimeter. is
can be easily removed using a spa surface cleaner or its equivalent. Avoid using
cleaning agents that leave soap residue in the water.
WARNING: Never allow your spa surface to be exposed to alcohol,
acetone (nail polish remover), nail polish, dry cleaning solution, lacquer
thinners, gasoline, pine oil, abrasive cleaners, or any other household chemicals
other than those listed. ese chemicals void the warranty.
Special Care For R Series Injection Molded JetPaks
High levels of sanitizer and normal use over time can have a bleaching eect
on the Injection Molded (dark gray) Jetpaks. ese can be cleaned / bued to
look like new again with the aid of Automotive Polishing compound found at
any automotive retailer. Simply use a soft towel to rub this compound onto the
plastic. en bu with a dry towel.