Troubleshooting guide

66
Most messages and alerts will appear at the bottom of the normally used screens. Several alerts and messages
may be displayed in a sequence. Some messages can be reset from the panel. Messages that can be reset will
appear with a “right arrow” at the end of the message. is message can be selected by navigating to it at
pressing the Select button.
– – –°F – – –°C
Water Temperature is Unknown
After the pump has been running for 1 minute, the temperature will be displayed.
Possible freezing condition
A potential freeze condition has been detected. All water devices are activated. In some cases, pumps may turn on and o and the heater may operate during
Freeze Protection. is is an operational message, not an error indication.
e water is too hot
e system has detected a spa water temp of 110°F (43.3°C) or more, and spa functions are disabled. System will auto reset when the spa water temp is below
108°F (42.2°C). Check for extended pump operation or high ambient temp.
A900 General Messages
General Messages
Most messages and alerts will appear at the bottom of the normally used screens.
Several alerts and messages may be displayed in a sequence.
Some messages can be reset from the panel. Messages that can be reset
will appear with a “right arrow” at the end of the message. This message
can be selected by navigating to it at pressing the Select button.
The water is too hot
The system has detected a spa water temp of 110°F (43.3°C) or more, and spa functions are disabled. System will auto
reset when the spa water temp is below 108°F (42.2°C). Check for extended pump operation or
high ambient temp.
Possible freezing condition
A potential freeze condition has been detected. All water devices are activated. In some cases, pumps may turn on
and off and the heater may operate during Freeze Protection.
This is an operational message, not an error indication.
– – –°F – – –°C
Water Temperature is Unknown
After the pump has been running for 1 minute, the temperature will be displayed.
Clean the filter `
DISPLAY MESSAGES & ERROR MESSAGES