INSTALLATION Manual Applications Ford 7.3L Power Stroke ‘99-’03 RFI Part Number 221103 Not legal for sale or use in California on pollution-controlled vehicles.
Introduction Introduction Introduction: The following instruction set covers installation and maintenance of the Rapid Flow induction system for ‘99-’03 7.3L Ford Power Strokes. The Bully Dog Rapid Flow Induction System has been designed to allow more air to flow though your engine. This allows a more complete burn of the fuel in your combustion chamber which adds additional horsepower and fuel economy. Note: This instruction set and the Rapid Flow Induction System included are made exclusively for the 7.
Removing Stock Intake Removing the Stock intake 1. Locate the stock air intake inside the engine bay on the driver side of the vehicle. 2. Loosen the hose clamp around the intake hose using a flat head screw driver and disconnect. 3. Remove the Stock Air Intake lid by unsnapping the two clamps on the side. 4. Remove Stock Air Filter and then clean the inside of the stock box before installing the Bully Dog air intake.
Installation Installing the RFI 1. Install the air filter onto the air intake tube of the Bully Dog RFI, tighten the clamp around the air filter outlet using a flat head screw driver. 2. Slide the new Rapid Flow Induction System into place. It will snap onto the base of the stock air box. 3.Connect the air intake Hose into the RFI system and secure the clamp by tightening it with a flat head screw driver. 4.
Filter Maintenance Filter Maintenance: The intake system should be cleaned at least once every three months; in dusty climates the filter should be cleaned more often. Use a Prefilter to extend time between cleaning. Cleaning the intake is a two part process, the first part of the process involves the physical cleaning of the filter with soap and water and the second part involves oiling the filter. To properly clean the filter, a Bully Dog cleaning kit should be used.
Pre Filter Bully Dog PreFilter (Part # 225101 for your intake) The time between scheduled filter maintenance can be extended. Using a Prefilter will prevent all large debris from getting into the ribs of the filter. When using the prefilter only fine dust particles make it through the prefilter and onto the exterior of the filter. Thus when using a prefilter, scheduled cleaning easy much easier and filter life is even positively effected.
Replacement Filter Bully Dog Replacement Filter In case your filter gets damaged, lost or stolen you can simply purchase a replacement filter from your local Bully Dog Dealer or from our website at www.bullydog.com. See the part number information below.
Doc.221103-99 v2.1 Check out more of our Adrenalin Pumping products! Triple Dog GT Pre Filter Cleaning Kits Clothing GT Diesel is not legal for sale or use in California on pollution-controlled vehicles. Free Technical Support at: 1-940-783-9915 See More at: bullydog.