Owner manual

Depending on how you plan to mount your device, the Armor can be installed in several ways.

If using Bully Dog’s 2 1/16

Pod Mount Adapter (30420),

make a small incision and tear

away the circular piece on the

Armor’s back side, insert the

device into the Armor and

insert the T-slot into the device.

If using Bully Dog’s available Ram Mount

T-Slot Adapter (30600-3), slide the adapter

into position on the device, and then insert

the ball end of the adapter through the

circular hole in the back side of the

Armor.

If using Bully Dog’s standard suction cup

mount (40400-102), ﬁrst insert the T-slot end

of the mount throught the circular hole in the back

side of the Armor. Attach the device to the T-slot on the

mount and pull both the device and the mount back into the Armor.

CMY

30700-1_inside_v2.pdf 1 8/6/13 3:54 PM