Owner's manual

4. Plug the male OEM MAP sensor plug into

the female Module MAP sensor plug.

5. Plug the female OEM MAP sensor plug in

the male Module MAP sensor plug.

6. Locate the ICP Sensor: like with the MAP sensor plug,

locate the ICP sensor and then follow the connected

wire harness to the plug set and disconnect that plug

set in preparation to tie in the Bully Dog harness. The

Injection Control Pressure sensor is located on the right

side of the engine near the front.

MAP w/ Rapid Power connected

INSTALLATION

Injection Control Pressure Sensor

Plug Set

L R