INSTALLATION Manual TRIPLE DOG DOWNLOADER Vehicle Application Triple Dog Part # OutLook Combo# ‘03-’05 Dodge 5.9L Cummins 40500 42500 ‘06-’07 Dodge 5.9L Cummins 40500 41500 ‘03-’07 Ford 6.0 L Power Stroke 40500 41500 ‘01-’05 GM 6.6L Duramax 40500 43500 ‘06-’07 GM 6.
TABLE OF CONTENTS Introduction TROUBLESHOOTING: Harness Description If you have questions during the installation of this product, please visit www.bullydog.com/Product_Updates.php. The latest version of these instructions can be found at the same location. Please review the Troubleshooting section on page 17 before calling technical support to cover most common issues. Technical support is available by calling 866-bullydog (866-285-5936). TABLE OF CONTENTS TRIPLE DOG INSTALLATION.......................
OUTLOOK INSTALLATION Introduction INTRODUCTION The Triple Dog Downloader, manufactured exclusively by Bully Dog Technologies is the only downloader on the market that allows on the fly tuning. The Triple Dog Downloader will fit either Ford 6.0L Power Stroke, GM 6.6L Duramax or Dodge 5.9L Cummins diesel pickups. Horsepower results and certain features this downloader offers will vary from vehicle to vehicle.
HARNESS DESCRIPTION Introduction OBD II PORT LOCATION Harness Description OutLook Installation Operating Instructions This is a very simple product to operate; all operations take place inside the cab of the vehicle with the downloader hooked up to the OBDII port. Operating the Triple Dog does not require any mechanical background. Refer to this instruction booklet for general guidelines through the download process and determining the different features available for your vehicle.
HARNESS DESCRIPTION Introduction Removing Fuses for ’01-’02 GM Duramax Vehicles IMPORTANT: Skip the steps on this page if your vehicle is not an ’01-’02 GM 6.6L Duramax . WARNING: Failure to remove the fuses while downloading the programs into the computer may result in computer hardware failure. Harness Description Note: Use your fuse puller included with your vehicle or a pair of needle nose pliers to pull the fuses.
OUTLOOK INSTALLATION Introduction Removing Fuses for ’03-’05 GM Duramax Vehicles IMPORTANT: Skip the steps on this page if your vehicle is not an ’03-’05 GM 6.6L Duramax . WARNING: Failure to remove the fuses while downloading the programs into the computer may result in computer hardware failure. •’03-’05 Duramax: Refer to Figure 2 to see the Harness Description fuses that must be removed prior to downloader installation.
OUTLOOK INSTALLATION Introduction OPERATING INSTRUCTIONS (INITIAL DOWNLOAD) IMPORTANT: The steps on this page are performed on all vehicles. Scroll Left Scroll Right Harness Description No/Exit Scroll Up OutLook Installation Yes/Enter Scroll Down Operating Instructions 1. Make sure that your key is in the ignition in the off position before you plug the downloader into the vehicle. The downloader will later prompt you to turn the key to the run position. 2.
OUTLOOK INSTALLATION Introduction Main Menu Options IMPORTANT: The information on this page is applicable to all vehicles. Harness Description OutLook Installation Operating Instructions INSTALL DOWNLOAD Select this option to download the on the fly programming. To work properly, the correct vehicle must be selected from the vehicle selection screen. This option also allows you to control the other vehicle specific features of the downloader.
OUTLOOK INSTALLATION Introduction INSTALL DOWNLOAD IMPORTANT: The information on this page is applicable to all vehicles. In these steps you will begin the downloading process.Select the “Install Download” option from the main menu and follow the screen prompts. Harness Description select vehicle To select the correct vehicle the correct files must first be loaded to the downloader, so it may appear as though vehicles have to be selected twice.
OUTLOOK INSTALLATION Introduction Ford 6.0L Power Stroke Vehicle Specific Features IMPORTANT: The information on this page is only applicable to Ford 6.0L Power Stroke Vehicles. Skip this page if your vehicle is not an ’03-’07 6.0L Power Stroke. Harness Description Speed Limiter The downloader gives racing enthusiasts the option to remove the OEM speed limiter. This allows the vehicle to reach speeds in excess of where the OEM speed limiter was set, usually at 98 mph.
OUTLOOK INSTALLATION IMPORTANT: The information on this page is only applicable to GM 6.6L Duramax vehicles. Skip this page if your vehicle is not a ’01-’07 6.6L Duramax. Harness Description Speed Limiter The downloader gives racing enthusiasts the option to remove the OEM speed limiter. This allows the vehicle to reach speeds in excess of where the OEM speed limiter was set, usually at 98 mph.
OUTLOOK INSTALLATION Introduction Dodge 5.9L Cummins Vehicle Specific Features IMPORTANT: The information on this page is only applicable to Dodge 5.9L Cummins vehicles. Skip the next two pages if your vehicle is not a ’03-’07 5.9L Dodge Cummins. Low end power: This feature will improve low-end throttle response over Standard Bully Dog Tuning. Harness Description Note: all the following features are available on ’06 & ’07 Dodge model years, but not all features will work on earlier models. 1.
OUTLOOK INSTALLATION Head Lamp Delay Use this feature to set the amount of time that the head lamps remain on after the vehicle has been turned off. Use the up/down arrows on the downloader to scroll in 5 second increments between 0 and 80 seconds. Harness Description Fog Lamp Enabling this feature will allow the fog lights and high beams to operate at the same time. This feature is for Off-road use only. Introduction Dodge 5.
OUTLOOK INSTALLATION Introduction ADJUSTING POWER On the fly IMPORTANT: The information on this page is applicable to all vehicles. Once the Triple Dog completes the download it will display the “On the fly” screen where you will choose your power setting. At this point it is OK to turn the vehicle on and drive it while you adjust your power.
OUTLOOK INSTALLATION IMPORTANT: The information on this page is applicable to all vehicles. Introduction OTHER TRIPLE DOG FEATURES Steps to adjustability: 2. Once you have successfully downloaded a power program you can install the Outlook and drive. When installed, the outlook monitor takes priority access over the downloader, and automatically integrates to adjust through the on the fly power settings of the Triple Dog without requiring any extra calibration. Harness Description 1.
OPERATING INSTRUCTIONS Introduction Harness Description OutLook Installation Operating Instructions Pyrometer Probe Calibration Troubleshooting 15 INTERNET UPGRADES IMPORTANT: The information on this page is applicable to all vehicles. Since the Triple Dog’s release, Bully Dog has consistently added new vehicle models and features to the Triple Dog. On many vehicle models there is an option to replace the Extreme setting on the Triple Dog with a Crazy Larry setting.
OPERATING INSTRUCTIONS IMPORTANT: The information on this page is applicable to the trucks outlined in the subheaders. If your vehicle is not listed, please skip these steps. Introduction TRANSMISSION RELEARN PROCEDURES Transmission Relearn Process GM 6.6L DURAMAX with Allison transmission 2. At a ½ throttle get up into 5th gear. Once you are in 5th gear, apply light pressure to the brake pedal until the truck is stopped. 3. At ¾ throttle get up into 5th gear.
OPERATING INSTRUCTIONS Introduction TRIPLE DOG Troubleshooting CONDITION Harness Description POSSIBLE SOURCES ACTION Downloader says Unknown part # Installation If the downloader says Unknown Part Number when you try to install go to the downloader center on www.bullydog.com and get the latest version. If problem continues call tech support.
OPERATING INSTRUCTIONS REMEMBER, THIS IS A PERFORMANCE PRODUCT, USE AT YOUR OWN RISK. This product is not intended to be used to break the law. DISCLAIMER OF LIABILITY Bully Dog Technologies, LLC. Its distributors, jobbers, and dealers (hereafter Seller) shall be in no way responsible for the product’s proper use and service. THE BUYER HERBY WAIVES ALL LIABILITY CLAIMS. The Seller disclaims any warranty and expressly disclaims any liability for personal injury or damages.
Bully Dog Technologies, LLC is a team built on integrity that is dedicated to leading the vehicle performance industry with an uncompromising code of ethics demonstrated in the soundness of its employees, excellent customer service and superior products. UNLEASH THE POWER WITH BULLY DOG PERFORMANCE PRODUCTS OutLook Monitor Intake Systems Custom OutLook Pod Exhaust Systems See More at: bullydog.com Doc.# BD40007 v1.0.2 For a full listing of Diagnostic Trouble Codes go to: www.bullydog.com/DTC.