User Manual
6
OUTLOOK INSTALLATION
Introduction Harness Description Operating Instructions Pyrometer Probe Calibration TroubleshootingOutLook Installation
OPERATING INSTRUCTIONS INITIAL DOWNLOAD
IMPORTANT: The steps on this page are performed on all vehicles.
1. Make sure that your key is in the ignition in the o position before you plug the downloader into the vehicle. The
downloader will later prompt you to turn the key to the run position.
2. Connect the cable that comes with the downloader into the top of the downloader and then into the OBDII port.
The OBDII port is the diagnostic port located underneath the steering wheel on the driver side of the vehicle.
3.The downloader will light up to display the rst
screen. Then follow the instructions given to you
on the screen of the downloader. The rest of these
instructions cover the main points of operating
the downloader, but do not cover screen to screen
guidance.
Scroll Left Scroll Right
No/Exit Scroll Down
Yes/Enter
Scroll Up