Service manual

-
rtpn
DOOT«l Sol
7WTWI
M
yroridHt
1.
A "nest" to hold « Power Oil during
testing.
The nest b clearly marked
for
proper
insertion of either the 214 Power Cell or the 213 Power Cell.
2. A meter, rending cither volls or
ulCrMUBpWVtt todfc*UU|
'he correct values
by
areas marked "OK."
3. A
-1
position Rotary Swildi lor the selection of the
VlrfOUl iMl
"'"fliiiutis:
Position i-"t:i
n-( ft
pi )W1-:k
( EH"
Position 2 -"OFF"
Position
:t "KKAUMICKOAMPKKKS
Position
4-
"LOW AMPLITUDE". In this position
the
Test
Set
supplier,
the
appropriate induced voltage for important Indexing Mechanism Adjustment,
for both the 214 and 2111 movements.
4. A 2-wire lend, wilh a lab end and a plug end for attachment to the 218 ACCUTRON
movement and movement holder.
5. A 2-wire lead, wilh a spring clip for attachment to the 214 ACCUTRON
movement.
6. A black screw, directly
below
the
center
of the
movement
dial, for
zeroing the
meter hand.
movement
bolder
The Movement Holder (Fig. 1
1
) is specially designed for the 218
ACCUTRON move-
ment and is used to hold the
movement whenever it
is
removed from the case. The
electrical jock on the Movement Holder is used
in
accommodate
the
plug tip
end of
the 2-wire lead from the Test Set
Fig. II
10