Safety data sheet

Page 4/10
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date
19.1.2016
Revision:
19.1.2016Version number 4
Trade name: BUNGARD GREENCOATING SPRAY
(Contd. of page 3)
41.2.25
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.
Pressurised container: protect from sunlight and do not expose to temperatures exceeding 50 °C, i.e. electric
lights. Do not pierce or burn, even after use.
·
7.2 Conditions for safe storage, including any incompatibilities
·
St
orage:
·
Requirements to be met by storerooms and receptacles:
Store in a cool location.
Observe official regulations on storing packagings with pressurised containers.
·
Information about storage in one common storage facility:
Not required.
·
Further information about storage conditions:
Protect from heat and direct sunlight.
·
7.3 Specific end use(s)
No further relevant information available.
*
SECTION 8: Exposure controls/personal protection
·
Additional information about design of technical facilities:
No further data; see item 7.
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
67-64-1 acetone
WEL Short-term value: 3620 mg/m³, 1500 ppm
Long-term value: 1210 mg/m³, 500 ppm
106-97-8 butane
WEL Short-term value: 1810 mg/m³, 750 ppm
Long-term value: 1450 mg/m³, 600 ppm
Carc (if more than 0.1% of buta-1,3-diene)
8050-09-7 Rosin
WEL Short-term value: 0.15 mg/m³
Long-term value: 0.05 mg/m³
Sen
108-65-6 2-methoxy-1-methylethyl acetate
WEL Short-term value: 548 mg/m³, 100 ppm
Long-term value: 274 mg/m³, 50 ppm
Sk
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes.
Avoid contact with the eyes and skin.
·
Respiratory protection:
Not required.
·
Protection of hands:
The gl
ove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
(Contd. on page 5)
GB