Service manual

(+) RED

(-) TANBLK

WHI

TEMP

READY

ENERGY SAVER MODE

ON OFF

HEATER

FIG. 20a DISPENSE SWITCH

Dispense

switch

Shroud

SERVICE (cont.)

Dispense Switch (H3E Element Only)

Location:

The dispense switch is located in the control panel.

Removal and Replacement:

1. Disconnect the dispenser from the power source.

2. Remove the top cover (3 screws) and front shroud

assembly (4 screws).

3. Remove the top 2 screws and loosen 2 lower screws

securing control panel to shroud.

4. Disconnect switch wires from the CBA.

5. Remove the large nut securing the switch.

6. Installation in the reverse order.

Test Procedures:

See disassembly procedure above.

1. Disconnect the switch harness from CBA.

2. Connect ohmmeter leads to the white and black

terminials . There should be continuity when switch

is pushed in.

3. Connect ohmmeter red lead to the red wire (+) and

black lead to tan wire (-). Select the various resis-

tance/continuity or diode scales to see if the LED

glows from the meter’s battery power source.

42311 070715

(+)

FIG. 20b DISPENSE SWITCH

FIG. 20c SWITCH TERMINALS