INSTALLATION & OPERATING GUIDE
3
INTRODUCTION
This equipment dispenses granita-type and cold liquid drinks on demand from separate hoppers. Operating controls
are accessible only through password protection.
CONTENTS
Warranty ........................................................................................................................ 2
Introduction
................................................................................................................... 3
Site Preparation, Electrical Requirements
...................................................................... 3
Initial Setup
.................................................................................................................... 4
Operating Controls
......................................................................................................... 6
Using the Dispenser for Granita-Type Products
............................................................. 8
Using the Dispenser for Cold Liquid Products
............................................................... 8
Programming
................................................................................................................. 9
Other Recommendations For Your Dispenser
.............................................................. 13
Required Regular Maintenance
.................................................................................... 13
Recommended Daily Cleaning
..................................................................................... 14
Autofill Cleaning Instructions
....................................................................................... 16
User Notices
................................................................................................................ 17
40563 040110
SITE PREPARATION
The dispenser is very heavy. Place it on a sturdy counter or shelf capable of supporting at least 180 lbs. It is
for indoor use only.
The dispenser must have at least six inches of space behind it. This space is needed for airflow, air filter
removal, and cleaning. A clearance of at approximately six inches is recommended between the dispenser sides
and the wall or another appliance. The dispenser performs better if not placed near any heating appliance. Leave
some space so the dispenser can be moved for cleaning.
ELECTRICAL REQUIREMENTS
CAUTION – Improper electrical installation will damage components. An electrician must provide electrical service as
specified below.
Model ULTRA-1 & 2, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch circuit
rated 120 volts ac, 15 amp, single phase, 60 Hz. The mating connector must be a NEMA 5-15R.
(Refer to the dataplate for exact electrical requirements.)
Model ULTRA-1A & 2A, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch circuit
rated 230 volts ac, 10 amp, single phase, 50 Hz. (Refer to the dataplate for exact electrical requirements.)
Model ULTRA-1B & 2B, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch circuit
rated 100 volts ac, 10 amp, single phase, 50 Hz. (Refer to the dataplate for exact electrical requirements.)
NOTE – Bunn-O-Matic does not recommend the use of any extension cord with these dispensers.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specied in conformance with all local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have been given instructions concerning use of this appliance by
a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with a special
cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.