Service and Repair Manual

17
TROUBLESHOOTING (cont.)
Freezes, but not
thick enough
Adjust thickness
screen higher
Check for slightly
bent auger shaft
pins and/or weak
torsion springs.
Check for dirty
or worn seals and
bushings.
Brix ratio
too high
Too much
alcohol in
product
Ambient
temperature
too hot
Adjust
product
Recommended
for indoor
use only
No hood lamps
Is dispenser in
“DAY” mode?
No
Yes
No
Yes
Set into
“DAY” mode
Is circuit breaker
tripped?
Check lamp circuit
Verify all 4 bulbs are 912
series & reset breaker
41084 102709