Service and Repair Manual

10. Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow all parts to soak for at

least 5 minutes. Carefully wash all components with a clean wash cloth in the hot water and sanitizer solu-

tion. Use a clean, soft bristle brush as needed for the smaller components and tight areas. Do not immerse

hopper lids. Use a commercial sanitizer that has 100 ppm of available chlorine with a concentration level

of at least 3% available chlorine (KAY-5 Sanitizer). Follow the sanitizer’s mixing instructions to ensure 100

ppm of available chlorine.

11. Wash the drums, hopper drip trays, top covers, and outer enclosure using a clean wash cloth that has been

dampened in the hot water and sanitizer solution. Pay particular attention to the shaft area and make sure

it is thoroughly cleaned and sanitized.

12. Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water. Wipe dry with

a clean dry wash cloth before reassembling the dispenser.

NOTE – Although most parts are dishwasher safe, they may be affected by the chemicals in some commercial

sanitizing agents. Do not place the hopper nor hopper lids in a dishwasher. Rinse thoroughly before assembly.

2. Depress the hopper lock plung-

er. Lift the hopper up slightly.

5. Remove the cooling drum seal

from the rear of the drum.

4. Pull the auger from the cooling

drum.

9. Care must be taken to ensure this surface does not get scratched dur-

ing cleaning. Deep scratches could cause leakage around the seal.

7. Carefully slide the faucet valve

up to remove the spring and

faucet seal. Extra care should

be taken when handling the

seal to prevent damage. Do not

fold the seal as this will cause

damage to the Teﬂon

sealing

surface.

6. Caution: The faucet valve is

under spring tension. Spread

one side of the handle ﬁrst, then

the other and disconnect from

the hopper.

8. Remove the auger nose bush-

ing from inside the hopper.

3. Pull forward to remove.

RECOMMENDED DAILY CLEANING (ULTRA-2 shown)

NOTE – Turn the power OFF to the dispenser before proceeding.

1. Empty all product from the hopper(s). Disconnect the hopper lid lamp cord(s) and remove the lids.

41084 102709