INSTALLATION & OPERATING GUIDE

13
OTHER RECOMMENDATIONS FOR YOUR DISPENSER
• Whether liquid concentrate or granulated powder, all product must be thoroughly mixed BEFORE adding it to the
hoppers.
• For best results with granita-type products, use only products with an apparent brix of 12 or higher. Some products
may work with an apparent brix as low as 9. Your experimentation with other products will be the best guide in this
area.
• Keep the pre-mixed liquid product refrigerated. This reduces cooling/freezing time in the dispenser.
• Keep the hoppers topped-off during peak serving periods. Add pre-mixed liquid product as it is dispensed. This reduces
the cooling/freezing time and assures you of always having product ready to dispense.
• Keep the product level in the hoppers higher than the auger. If the auger is exposed, air will become entrapped in the
mixture resulting in a clouded foamy consistency.
• You may nd it benecial to turn down the ice controls to keep the ice granules from growing too large. Refer to
Programming The Dispenser on page 10 for Setting the Consistency.
• Some products freeze at a lower temperature than others. You may notice frost or ice on the hoppers. This is normal
and should not be a concern.
• Humidity in the air may cause sweating on the outside surfaces of the hoppers. This is to be expected and should
not be a concern. The drip trays beneath the hoppers will capture this and cause it to flow to the lower drip tray for
disposal.
• Some noises are to be expected during normal operation of the dispenser. By becoming familiar with the noises made
during normal operation, you will be better able to listen for problems.
40563 011910
PREVENTIVE MAINTENANCE
Bunn-O-Matic
®
Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance
should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic
®
Corporation at
1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.
Cycle
(months)
6
6
6
6
6
6
monthly
6 or as
needed
6 or as
needed
6
Item
Replace hopper drum seal.
Replace faucet seal.
Inspect auger shaft for abnormal wear.
Replace the auger shaft bushing
Replace the cooling drum seal.
Lubricate the motor shaft and motor shaft groove.
Clean condenser air filter.
Clean condenser coil.
Inspect and clean the condenser fan.
Inspect, clean, or replace the hopper tray drain tubes.