52000.0300
BUNN® reserves the right to change specifications and product design without notice. Such revisions do not entitle 
the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment. 
For most current specifications and other info visit bunn.com.
Last Updated:
06/28/2021
ITB Dual Dilution w/Sweetener
Server(s) sold separately
Sleek, modernized design language on the brewer, with rounded angles on the 
corners and trunk
Digital readout displays in English, Spanish, or French ---for easier programming 
and control--- and can show either 'Standard' or Metric measurements. Digital 
readout also shows machine status, and targeted advertising messages can be 
programmed for display.
BUNN Infusion Series technology allows for multiple recipes from one footprint --- 
with three brew buttons and two batch sizes
Electronic funnel lock prevents removal of each brew funnel until drip- through is 
complete
USB programming capable
Pre-infusion and pulse brew for maximum flavor extraction. Cold brew lockout & 
digital temperature control further ensure top-notch brewing. 
Specifically designed to accommodate and brew into two BUNN 3.5gal Narrow Tea 
Dispensers (can also brew directly into standard tea dispensers)
Each brew button’s sweetener may be independently set and easily adjusted using 
the Sweet Meter
"Out of Sweetener" indicator - LED blinks to aid operator
Separate inlet for sweetener - use existing CO2 systems or external 3rd party pump 
for sweetener delivery
Dilution nozzles labeled "Sweet" and "Unsweet”
Agency:
Specifications Additional Features
 52000.0300Product #: Funnel Locks
 PlumbedWater Access:
 Stainless
Finish:
 Translucent Tea FunnelFunnel:
Height: 35.0" Width: 12.2" Depth: 22.9"
(88.9cm) (31.0cm) (58.2cm)
 Electrical & Capacity
Volts* Amps Watts
Cord 
Attached
Plug Type
8oz cups/hr 
236ml cups/hr
Input H²O 
Temp.
Phase
# Wires 
plus Ground
Hertz
120 14 1700 Yes NEMA 5-15P 336
60°F (15.5°C)
1 2 60
*When a BUNN is machine rated 120/208-240V, 120/208V or 120/240V, the higher voltage is the supply voltage needed to power the machine. The 120V is there to supply power to some components rated 120V in the machine, but it is not the supply voltage 
and would not power the machine if the machine is marked with the before mentioned ratings.
Plumbing Requirements CAD Drawings
PSI kPa
Fitting Supplied
Water Flow Required (GPM)
20-90 138-621
1/4" Male Flare Fitting
1.25
2D
Revit 
KLC
•    
This product can expose you to chemicals including Bisphenol A (BPA), which is known to the State of California to cause birth defects or other reproductive harm. For more 
information go to www.P65Warnings.ca.gov
WARNING:




