Owner's Manual

12
INITIAL BREWER SET-UP (MCP/MCPA)
7
Fill the Primer Bulb (O) with water by
squeezing the bulb while in the Water
Reservoir.*
8
Place the tip of the “Primer Bulb” over
the Water Reservoir Exit.
9
Press the “Coffee Brew Button” while
applying a small amount of downward
pressure on the “Primer Bulb” then
squeeze to dispense the water from
the bulb. Raise the “Primer Bulb” from
the Water Reservoir Exit to allow the
internal water pump to pull water from
the Water Reservoir.
NOTE: Repeat Step 7 & 8 until the unit is
primed, i.e. water is dispensing from the
Pod Holder into the cup.
10
If the “Rell Water Indicator” is no
longer ashing the initial setup is com-
plete. Wait for the “Heating Indicator” to
go out before brewing a fresh cup.
*NOTE: Filling the Water Reservoir by
pressing the “Coffee Brew Button” once
will be required for Automatic units prior to
completing Step 7.
NOTE: Squeezing the bulb with the whole
hand rather than just the nger tips will
give better results.