Owner's Manual

UPDATE PROGRAMMING USING USB STICK

1. Press and hold right hidden button to enter setup menus (reference page 8 for steps). Scroll to

“REVIEW RECIPES?” screen, and push the button under “YES”.

Then, scroll to each coffee name corresponding to the names on the hoppers being used, and press

the button under “SHOW”.

NOTE: Record the grind times for each batch size of each coffee used, for later use.

continued >

2. Disconnect grinder from power source.

3. Remove two (2) screws holding control panel on the front of the

grinder, and set screws aside.

4. Hang the control panel on the designated tab holders as shown.

5. Remove the protective cover on the USB port on the control board.

6. Insert the USB stick into the port.

7. Plug in the grinder. When prompted on the display to proceed with

software update, select the right hidden switch under the display.

8. Allow time for the software update to ﬁnish.

9. When complete, remove the USB from the port.

10. Place the protective cover back onto the USB port on the

control board.

11. Reinstall the control panel and secure using the two screws.

12. Power cycle the grinder, the new software version will display on

the screen before initializing the home screen.