Programming Manual

Page 13
20. When finished setting both batch sizes, press
DONE. The display will show the pulse settings to
accommodate the brew time entered. Press and
release each batch size to display the settings for
that batch. After a delay, the display should read 3
BATCHES DONE?
21. If both batch sizes are not correct, press NO to
return to the BREW TIME setup screen and repeat
steps 18-20.
Setting Pulse Brew/PreInfusion – MANUAL
22. Select MANUAL. With MANUAL flashing, select
NEXT.
23. The display should now read, 1
st
ON TIME and a
batch light will be blinking. Select the batch size to
be modified.
24. Using (-) or (+), adjust the 1
ST
ON TIME.
25. When finished, press the other batch size and repeat
step # 24.
NOTE: To disable pulse brew, set 1
ST
ON TIME to OFF.
Brewer will automatically pulse on tea recipes with a
brew volume greater than 86.0 oz.
26. When finished setting both batch sizes, press DONE.
27. The display should now read OFF TIME. Adjust the
OFF TIME using (-) or (+).
28. When finished, press the other batch size and repeat
step # 27.
29. When finished setting both batch sizes, press and
release DONE.
30. The display should now read LAST ON:. Adjust the
LAST ON TIME using (-) or (+). If PREINFUSION
is desired, set the LAST ON TIME to PreI.
31. When finished, press the other batch size and repeat
step # 30.
32. When finished setting both batch sizes, press and
release DONE.
33. The display will show the three times just entered.
Press and release each batch size to display the set-
tings for that batch. If the 1
ST
ON TIME is set to OFF,
the display will read PULSE BREW DISABLED. After
a 5 second delay, the display will read 3 BATCHES
DONE?
INITIAL SPRAY
INITIAL SPRAY
ALTERNA
TES UNTIL
BREW CYCLE IS
COMPLETED
PRE-INFUSION
REMAINING ON
ON-
TIME
OFF-
TIME
OFF-TIME
OFF-
TIME
OFF-
TIME
ON-
TIME
ON-
TIME
9. If both batch sizes are correct, press YES. This will
advance to the BYPASS %
10. Using (-) or (+), set the amount of bypass water for
that particular batch size to be dispensed around
the filter/grounds.
11. When finished, press the other batch size and repeat
step #10.
12. When finished setting both batch sizes, press and
release DONE. The display should read 3 BATCHES
DONE?
13. If all batch sizes are not correct, select NO to return
to the BYPASS % function and repeat steps #10-12.
14. If both batch sizes are correct, press YES. This will
advance to the SET PULSE BREW.
15. To set PULSE BREW press YES. The display should
now read SELECT METHOD. To set the EASY method,
continue to step # 16. To set by MANUAL method,
jump to step # 21.
(cont.)
Setting Pulse Brew – EASY Pulse Brew
Range: Minimum: will adjust to the minimum time
required to brew that batch using the set brew volumes
and flow rate for the sprayhead. Maximum – will adjust
depending on settings and will always be minimum time
+ 3 minutes. The brewer will automatically calculate what
the 1ST ON TIME, OFF TIMES, and LAST ON TIME will
be using THE INITIAL ON TIME, plus a 7 pulse routine.
16. Select EASY. With EASY flashing, select NEXT.
17. The display should now read BREW TIME: and a
batch light will be blinking. Select the batch size to
be modified.
18. Using (-) or (+), set the total brew time desired
including spray times and off times.
19. When finished, press the other batch size and repeat
step # 18.
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS (cont.)
53669 041817