Programming Manual

Page 14
34. If all the pulse brew settings for both batch sizes
are not correct, press and release NO to return to
the 1
ST
ON TIME setup screen and repeat steps 18
through 33.
35. If all batch sizes are correct, press YES. The display
should now read DRIP TIME.
Setting DRIP TIME:
NOTE: Drip time also controls the solenoid on time
for models with optional funnel locks.
26. The display should now read DRIP TIME, along with
either the word OFF or a time showing. A batch
light will also be blinking.
27. Using (-) or (+), set the amount of time from when
the brew spray ends to when the funnel is emptied
of hot liquid.
28. When finished, press the other batch sizes and
repeat step #27.
29. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCHES
DONE?
30. The display will read SH TEMP XXX°.
31. Using (-) or (+), set temp for SH Server to maintain
if that recipe is brewed.
32. When finished, press the other batch sizes and
repeat step #31.
33. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCHES
DONE?
34. The display will now read FRESH X:XX HRS.
35. Using (-) or (+), set fresh time for recipe.
36. When finished, press the other batch sizes and
repeat step #35.
37. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCHES
DONE?
38. Select YES. The screen should show the name of
the recipe being programmed (modified) along with
SETUP COMPLETE.
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS (cont.)
53669 041817