Programming Manual

Page 19
11. Repeat step 10 until the top line is complete.
12. Select DONE. The display should now read WRITE
BTM LINE?.
13. To write the bottom line, select YES.
14. To skip the bottom line, select NO.
a. If neither a top nor bottom line was written, the
display should now read ENABL SANITATION.
b. If only a top line was written, the ad will be
displayed followed by SAVE? Proceed to step 18.
15. The display will now read A with a flashing cursor
below it. Scroll through the alphabet and available
characters. When the desired character is shown
on the display, select NEXT to move to the next
character in the bottom line.
16. Repeat step 15 until the bottom line is complete.
17. Select DONE. The display will now show the written
ad, and then SAVE?
18. To cancel saving the ad, select NO. The display
should now read ADVERTISEMENT NOT SAVED!
and then will return to the NEW AD screen.
19. To correct or edit the ad, select EDIT. The display
should now read WRITE TOP LINE? Repeat steps
10 though 17.
20. To save the ad as it is shown, select YES. The
display should now read ADVERTISEMENT SETUP
COMPLETE, and then ENABL SANITATION. To exit
programming and return to the MAIN SCREEN,
press ENABLE BREW ON/OFF switch.
Procedure to READ in a new Ad:
NOTE: Saving a new ad will erase any previously saved
ad in the brewer’s memory.
7. From the NEW AD? screen, select CARD.
8. The display will show INSERT AD CARD. Place
the AD CARD vertically so that the top end of the
"chip" is beneath the sensing coil (located on the
underneath side of the front display panel).
9. After a short pause, the display will read CARD
CONTAINS AD. To view the ad, press and release
SHOW. To save the ad to the brewer's memory,
select SAVE. To cancel, select QUIT.
10. After the ad is saved, the display will read AD MES-
SAGE SETUP COMPLETE.
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS (cont.)
53669 041817