PROGRAMMING MANUAL BUNN-O-MATIC CORPORATION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 FAX: (217) 529-6644 41170.
BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal servers and Thermofresh servers (mechanical and digital)- 1 year parts and 1 year labor. 2) All other equipment - 2 years parts and 1 year labor plus added warranties as specified below: a) Electronic circuit and/or control boards - parts and labor for 3 years.
CONTENTS LOCKOUT SWITCH .............................................................................................4 PROGRAMMING SWITCHES...............................................................................5 PROGRAMMING .................................................................................................
ADJUSTMENTS & PROGRAMMING PROGRAMMING THE BREWER The programming of the brewer is divided into two levels. Brewing adjustments are in Level 1. Service functions are accessed in Level 2. The following function screens are in order of appearance. Each screen will have instructions on how to access, and the procedures to program the various functions of the brewer. IMPORTANT PROGRAMMING NOTES - READ CAREFULLY To exit the programming mode at any time, press and hold "Hidden" switch located on the front panel.
PROGRAM FUNCTIONS MAIN SCREEN R WE RE B OD toP Au HIDDEN SWITCH Press until display reads "BREW LOCKOUT" Press/hold to exit program LL BR BRE E SMALL BREW Step backwards through screens BREW LOCKOUT: NEXT BREW LOCKOUT ? NO DONE YES Prevents brewing if the water temperature is less than the "SET READY" temperature. To access this function screen press and hold the hidden switch. Release when the display reads: "BREW LOCKOUT". The YES or NO should be flashing.
PROGRAM FUNCTIONS BREW TYPE A TEA DONE COFFEE BREW OZ A: (-) BREW OZ. (A/B) (1-16) Adjust brew volume. 8.0 DONE (+) BREW METER A: 2 - + ENTER SERVICE #? NO YES ENTER PASSWORD 0 0 0 SET PASSWORD 0 0 0 SET LANGUAGE ? NO YES UNITS METRIC DONE ENG SET TEMP: (-) 200° DONE (+) SET READY: 195° (-) DONE DONE DONE ENTER PASSWORD User must enter a 3 digit number to access remainder of adjustments. If no number has been pre-programmed (0 0 0), then access is allowed.
PROGRAM FUNCTIONS DRIP T I M E A/B: 15 (-) DONE (+) BREWS TO EMPTY (-) 25 (+) Enabl EnergySavr NO DONE YES AIR PUMP POWER 4 (-) DONE (+) BREW COUNT ## NO YES BREW COUNT ## RESET NO YES PRESS BREW TO START ENTER OZ DONE 10.0 (+) SERVICE TOOLS ? NO YES TEST OUTPUTS ? NO YES INDEX B DUMP NEXT TOR MOTOR LOAD AL R EXTERNAL RELAY ON BREWS TO EMPTY (OFF/15-25) Set number of used pods in bin to turn on "EMPTY BIN" message.
WaterInIet ON # NEXT OFF AIR PUMP ON NEXT OFF HOT WATER ON NEXT OFF VENT VALVE ON NEXT OFF WATER PUMP ON NEXT OFF HotWaterAir PUMP ON NEXT OFF TANK HEATER ON NEXT OFF TEST SWITCHES ? WITC NO WATER INLET Activates the water inlet valve for the brew tank, and flow meter count. AIR PUMP Activates the air pump motor for the brew tank. HOT WATER Activates the water inlet solenoid for the hot water tank. VENT VALVE Activates the vent solenoid for the hot water tank.
Page 9 411701 061308