Repair manual

Page 13
Faceplate Removal and Replacement:
1. Disconnect brewer from power source.
2. Disconnect the wires from the relay on the control
board.
3. Disconnect the 10-pin connector (main harness)
and the 3-pin connector (level probe harness) from
the control board.
4. Disconnect the 10-pin connector (ribbon cable)
from the control board.
5. Drain tank and disconnect/remove faucet.
6. Remove the 3 nuts and 1 standoff from back side
of faceplate assembly.
7. Remove faceplate and control board as an assembly
out the front opening.
FACEPLATE REMOVAL
FIG. 13-1 FACEPLATE REMOVAL
8. Remove the two screws and two nylon washers
securing the control board to the front face plate.
9. Place the bottom edge of the new control board in
the two cradles and secure with the two screws and
nylon washers to the front face plate.
NOTE: The nylon washers must be installed under
the heads of the two screws to prevent a possible
shorting of the control board circuits.
10. Re-install faucet assembly (if equipped).
11. Re-install faceplate/board assembly.
12. Re-install wires & connectors.
39132 061809