User's Manual

1. Remove dispenser from the box and place on a sturdy, level counter.

2. Remove the brass cap and any packing material from the end of the water inlet ﬁtting located on the rear of

the dispenser.

3. Attach a 1/4" water line to the inlet ﬁtting. This supply line must have at least 30 psi of pressure.

4. Using a screwdriver, turn the adjustment screw on the venturi mixer clockwise until the screw contacts the

seat (DO NOT OVERTIGHTEN THIS SCREW!).

5. Turn on the water supply and open the water inlet valve on the rear of the dispenser and check for leaks in

the system.

6. Place a container under faucet(s); fully open the faucet(s) for approximately 10 seconds to remove all the air

out of the lines, then close the faucet(s). Discard the water.

7. Connect the proper BIB (Bag in a Box) adapter(s) to the concentrate inlet tube(s) and clamp. If bottle con-

centrate is used, connect the stainless formed tube(s) to the inlet hose(s) and clamp.

8. Attach the connector(s) to the BIB, or insert the bottle adapter into the bottle(s).

9. Place the concentrate container(s) in the location they will be used for normal operations.

a. In the dispenser housing: Coil the tube in the dispenser and place the BIB (bottle) on top of the coiled

tubing with the connector facing down, under the bag.

b. Under the counter: Place the BIB under the counter and rout the tubing to the dispenser, avoiding sharp

bends and kinks. Cut off excess tubing to keep the over length of tubing to minimum.

NOTE: It is critical that the dispenser is upright and the concentrate container(s) be in the proper location and

orientation that they will be during normal operation, before making any strength adjustments.

10. Slide the dispenser to the edge of the counter to gain access to the adjustment screw from the bottom.

11. Turn the adjustment screw approximately 1/2 turn counterclockwise.

12. Place a container under the faucet(s) and open faucet(s) until the entire concentrate line(s) ﬁll and tea is

dispensed for approximately 5 seconds. Close the faucet(s). Discard this solution.

13. Place a glass under the faucet and open to ﬁll the glass. Adjust the screw to achieve the desired strength

of tea. To increase the amount of concentrate (stronger tea), turn the adjustment screw counterclockwise

slightly (1/16 to 1/8 of a turn at a time). To reduce the amount of concentrate (weaker tea), turn the adjust-

ment screw clockwise slightly (1/16 to 1/8 of a turn at a time).

14. Dispense a couple of 8 ounce glasses of tea after each adjustment and test for taste or color. Continue this

process until the taste or color proﬁle is achieved.

NOTE: The ratio adjustment setting is very sensitive. Make very small adjustments with the screw, then taste or

color check the results. You do not have to turn the screw very much to change the ratio.

15. Once the desired ratio of concentrate to water has been set, slide the dispenser back to the desired location

on the counter top. For under counter BIB’s, make sure the tubes do not get kinked, when the dispenser is

slid back into place.

The dispenser is now ready for use.

SET UP AND OPERATING PROCEDURES

47629 121012