Owner's Manual

INITIAL SET-UP

1. Locate the drip tray assembly beneath the dispenser nested in the packing material.

2. Remove the drip tray and the drip tray cover and set them aside.

3. Remove the water strainer assembly from the drip tray and set it aside.

4. Remove the four legs from the drip tray, apply non-skid pads to the bottom of the legs and securely install

the legs in the dispenser base.

ELECTRICAL REQUIREMENTS

CAUTION - The dispenser must be disconnected from the power source until specified in

Initial Set-Up.

The 120 volt version of this dispenser has an attached cordset and requires 2-wire, grounded service rated 120

volts ac, 15 amp, single phase, 60 Hz. The mating connector must be a NEMA 5-15R.

The 120/208 and the 120/240 versions of this dispenser has an attched cordset. The mating connector must be

a NEMA 14-20R.

(

Refer to the dispenser’s dataplate for exact voltage requirement.)

ELECTRICAL HOOK-UP

CAUTION – Improper electrical installation will damage electronic components.

1. An electrician must provide electrical service as specified.

2. Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.

3. Open the front door of the dispenser and place the heater switch in the “OFF” (upper position).

4. Connect the dispenser to the power source.

5. If plumbing is to be hooked-up later be sure the dispenser is disconnected from the power source. If

plumbing has been hooked-up, the dispenser is ready for

Initial Fill & Heat.

PLUMBING REQUIREMENTS

This dispenser must be connected to a COLD WATER system with operating pressure between 20 and 90 psi

(138 and 620 kPa) from a

⁄2" or larger supply line. A shut-off valve should be installed in the line before the

dispenser. Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi (345

kPa). The water inlet fitting is

⁄4" flare.

NOTE - Bunn-O-Matic recommends

⁄4" copper tubing for installations of less than 25 feet and

⁄8" for more than

25 feet from the

⁄2" water supply line. At least 18 inches of an FDA approved flexible beverage tubing, such as

reinforced braided polyethylene or silicone, before the brewer will facilitate movement to clean the countertop. It

can be purchased direct from Bunn-O-Matic (part number 00326-0000). Bunn-O-Matic does not recommend

the use of a saddle valve to install the brewer. The size and shape of the hole made in the supply line by this type

of device may restrict water flow

This equipment must be installed to comply with the Basic Plumbing Code of the Building

Officials and Code Administrators International, Inc. (BOCA) and the Food Service Sanita-

tion Manual of the Food and Drug Administration (FDA).

28364 051000