Owner's Manual

6
CLEANING
WARNING – Unplug grinder before the removal of any panel or grind chamber-housing parts.
1. Clean all exterior surfaces using a damp cloth rinsed in any mild, nonabrasive, liquid detergent. Care should be taken
not to scratch the grinder with any abrasive material.
2. Remove the hopper by sliding all the way forward.
3. Remove the lid from the hopper, and empty of beans.
4. Clean and sanitize the hopper and lid. Care should be taken not to scratch the hoppers with any abrasive material.
5. Place an empty funnel with filter in the funnel rails. Press and release the “GRIND” button. Run a few cycles until all
coffee in the grind chamber is dispensed and disconnect the grinder from the power source.
6. Remove the funnel and filter and discard any remaining coffee grounds.
7. Remove two black screws from the lower control panel bezel.
8. Remove the control panel and hang the control panel on front of grinder by inserting metal tabs on the back of control
panel into slots on the front of grinder.
9. Remove the two screws holding the front cover to the burr housing. Carefully remove the burr housing front cover.
Clean inside surface with a dry stiff non-metallic bristle brush and wipe with a dry clean cloth.
10. Carefully remove the rotor cup, shear plate, burr rotor and motor shaft extension from the grinder. Clean all parts with
a dry stiff non-metallic bristle brush and wipe with a dry clean cloth.
11. Clean the grind chamber with a dry stiff non-metallic bristle brush and wipe with a dry clean cloth.
12. Reinstall the motor shaft extension, burr rotor, shear plate, rotor cup and front cover to the burr housing.
13. Reinstall the front control panel.
14. Refer to the “Adjustment” section of the Operating and Service manual for burr adjustment.
15. Reinstall the cleaned hopper on the grinder.
Align rear of hopper
with rails for proper
installation.
41451.0001 031111
PREVENTIVE MAINTENANCE
Bunn-O-Matic
®
Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance
should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic
®
Corporation at
1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.
6-Month
Weekly Cleaning plus replace the dechaffer assembly.
05995.1000 Dechaffer Plate (package of 6)
1-Year
1. On grinders with slide plates check the slide plates and clean.
2. Inspect and clean/replace burrs and grind chamber if necessary.
3. Adjust the burrs and grind time to your specifications for particulate size and throw weight.