LPG LPG-2E INSTALLATION & OPERATING GUIDE BUNN-O-MATIC CORPORATION OF CANADA 280 INDUSTRIAL PARKWAY SOUTH, AURORA, ONTARIO, L4G 3T9 PHONE: (905) 841-2866 FAX: (905) 841-2775 To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and manual updates.
BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corporation of Canada (“Bunn”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal servers and Thermofresh servers (mechanical and digital) - 1 year parts and 1 year labour. 2) All other equipment - 2 years parts and 1 year labour plus added warranties as specified below: a) Electronic circuit and/or control boards - parts and labour for 3 years.
CONTENTS User Notices..............................................................3 Electrical Requirements.............................................4 CE requirements........................................................4 Operating Controls.....................................................4 Cleaning.....................................................................5 Coffee Grinding..........................................................5 Initial Set-Up..............................
ELECTRICAL REQUIREMENTS The grinder has an attached cordset and requires 2-wire, grounded service rated 120 volts ac, 15 amp, single phase, 60 Hz for 120V models; 100 volts ac, 15 amp single phase, 50Hz for 100V models. OPERATING CONTROLS Off/On/Start Switch (Models LPG and LPG-2E) OFF - (upper position) Switching to this position stops all operation of the grinder.
CLEANING EXTERIOR SURFACES The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. Care should be taken not to scratch the hopper or windows with any abrasive material. Regular cleaning will keep your grinder looking new for years. GRIND CHAMBER 1. WARNING - Unplug grinder before removal of any panel or grind chamber housing parts. 2. Empty all beans from both hopper(s). 3.
INITIAL SET-UP/ADJUSTMENTS The grind can be set from fine to very coarse. The grind may be adjusted for use in most commercial coffee brewers. The following procedures should be used to make adjustments. NOTE - A change in the burr adjustment will also change the amount dispensed. Any adjustment to the burrs should be followed by an adjustment of the timer dials. R SE - F INE A Burr Adjustment CO 1. Unplug the grinder and empty all beans from the hopper(s). 2.
RÉGLAGE INITIAL ET AJUSTEMENTS La mouture peut aller d’extra-fine à grosse. Elle peut être ajustée pour convenir à la plupart des infuseurs à café commerciaux. Il faut suivre la procédure suivante pour effectuer des ajustements. NOTE - Un ajustement effectué à la vrille aura pour effet de modifier la quantité moulue. Tout ajustement à la vrille devrait être suivi d’un ajustement de la minuterie. R SE - F INE A Ajustement de la vrille CO 1. Débranchez le moulin et videz les trémies de tout grain de café.
NETTOYAGE SURFACES EXTERNES Il est recommandé d’utiliser un linge humide rincé dans un détergent liquide doux non abrasif pour nettoyer toutes les surfaces externes des appareils Bunn-O-Matic. Prenez soin de ne pas égratigner la trémie ni les vitres avec des produits abrasifs. Un nettoyage régulier permettra de conserver l’apparence neuve de votre moulin pendant de nombreuses années. COMPARTIMENT DE MOUTURE 1.
ALIMENTATION ÉLECTRIQUE Ce moulin est muni d’un cordon d’alimentation et doit être raccordé à un circuit bifilaire mis à la terre, d’une tension nominale de : 120 V c.a., 15 A, monophasé, 60 Hz pour les modèles 120 V, 100 V c.a., 15 A, monophasé, 50 Hz pour les modèles 100 V. COMMANDES DE FONCTIONNEMENT Interrupteur marche-arrêt/bouton de démarrage (modèles LPG et LPG-2E) ARRÊT (vers le haut) : Si l’interrupteur est placé vers le haut, le moulin s’arrête de fonctionner.
TABLE DES MATIÈRES Introduction...............................................................3 Avis à l’utilisateur.......................................................4 Norme européenne (CE) ............................................4 Commandes de fonctionnement................................4 Nettoyage...................................................................5 Mouture du café.........................................................5 Réglage initial et ajustements................
BUNN-O-MATIC GARANTIE DE PRODUIT COMMERCIAL Bunn-O-Matic Corporation of Canada (« Bunn ») garantit les appareils qu’elle fabrique ainsi : 1) Cafetières, carafes thermiques, carafes à décanter, serveurs GPR, distributrices de thé glacé / de café glacé, infuseursnacelle de type MCP/MCA, serveurs thermiques et serveurs de type Thermofresh (mécanique et numérique) - 1 an pièces et 1 an main-d’œuvre.
LPG LPG-2E MANUEL D’INSTALLATION ET D’UTILISATION BUNN-O-MATIC CORPORATION OF CANADA 280 INDUSTRIAL PARKWAY SOUTH, AURORA, ONTARIO, L4G 3T9 TÉLÉPHONE: (905) 841-2866 TÉLÉCOPIEUR (905) 841-2775 Pour obtenir la plus récente version du manuel d’utilisation ou pour visualiser le catalogue illustré de pièces, le manuel de programmation ou le manuel d’entretien, visitez le site Internet de Bunn-O-Matic, à l’adresse www.bunn.com. Ces manuels sont GRATUITS et le téléchargement des mises à jour est rapide.